2-component clear lacquer Rapid - CLRLACSPR-2K-RAPID-CLEARCOAT-250ML

2-component clear lacquer Rapid

Name: 2-component clear lacquer Rapid
Brand: Würth
SKU: 5867000124

2C clear lacquer RAPID
CLRLACSPR-2K-RAPID-CLEARCOAT-250ML

Art.-no. 5867000124

EAN 4050382131737

All versions

Similar products

Prices for customers after login

2-component clear lacquer Rapid

Art.-no. 5867000124

Prices for customers after login

Quantity

Show availability in Würth branch offices

Exclusively for trade customers

Locate branch office
Login/Register
Call customer service: +43 50 8242 0

For permanent sealing of touched-up surfaces and newly painted small parts

Very quick-drying, good running two-component clear varnish with excellent resistance to weathering, chemicals and petrol

High output rate

Quick to dry

Constant atomisation pressure until completely empty

Excellent resistance to wear and scratches

Ideally suited for spot repair work

Notice

Processing time following activation: max. 14 hours. After use, turn the can upside down and spray until the valve is empty.

REGULATION (EU) 2019/1148 on the marketing and use of explosives precursors: This product is regulated by Regulation (EU) 2019/1148: All suspicious transactions, as well as the loss and theft of significant quantities, must be reported to the relevant national contact point (Federal Criminal Police Office, Office 3.3). The acquisition, introduction, possession or use of the restricted explosive precursor in question by members of the general public is subject to a restriction as set out in Article 5(1) and (3), and to a reporting obligation as set out in Article 9.
See https://www.bmk.gv.at/themen/klima_umwelt/chemiepolitik/recht/eu_vo/ausgangsstoffe-explosiv.html

Product information

Würth Catalogue

Datasheets(X)

Safety data sheet

Certificates/ Documents

Application area

For high-quality and permanent painting of solvent-based and water-based paint systems.

Instructions

Shake the can well for 2 minutes before spraying. Remove the red push button from the cap, put in the pin at the base of the can and push the pin in as far as it will go; remove and dispose of the red push button. Shake the can well for another 2 minutes. Apply 1-2 thin spray coatings to the prepared surface. Observe the intermediate flash-off time! Yield 250 ml: Approx. 0.5-0.75 m. Dust-dry: 7 minutes Touch dry: 6 hours

Chemical basis	Two-component resin
Contents	250 ml
Dust-drying time	7 min
Container	Aerosol can
Density	0.904 g/cm³
Density conditions	at 20°C
Shelf life from production	24 Month

Fitting products for your order

2-component clear lacquer Rapid