DP 300 engine and housing sealing compound
Engine and housing sealing compound DP 300 NSF
ENGSEALCOMPD-DP300-TUBE-RED-80ML
Register now and access more than 60,000 products
- Excellent sealing ability thanks to permanently plastic (non-hardening) properties
- Resistance to vibration guaranteed even after years of exposure
- No pulling of threads during application
- Does not run on vertical or downward-sloping surfaces
- Temperature-resistant from -50°C to +270°C; for brief periods up to +300°C
- Poor thermal conductivity
- Does not bond to metals or other materials chemically, prevents atmospheric corrosion
- Resistant to water, air, gasoline, kerosene, a variety of oils, synthetic lubricants, water/glycol and methanol mixtures, anti-freeze, fluorocarbon cooling agents
- Silicone-free
- Non-toxic
- Can only be used together with solid seal
- Not suitable for sealing oil sumps
NSF registered, category P1, reg. no. 151822
REGULATION (EU) 2019/1148 on the marketing and use of explosives precursors: This product is regulated by Regulation (EU) 2019/1148: All suspicious transactions, as well as the loss and theft of significant quantities, must be reported to the relevant national contact point (Federal Criminal Police Office, Office 3.3). The acquisition, introduction, possession or use of the restricted explosive precursor in question by members of the general public is subject to a restriction as set out in Article 5(1) and (3), and to a reporting obligation as set out in Article 9.See https://www.bmk.gv.at/themen/klima_umwelt/chemiepolitik/recht/eu_vo/ausgangsstoffe-explosiv.html
Datasheets(X)
- For sealing engines and housings in the automotive and motorcycle industry, tractor construction, electrical industry, turbine and nuclear power plants, mechanical engineering, gear construction, food industry, in gas, water and electricity plants, pump construction and mining
- For sealing particularly demanding and critical sealing connections due to its excellent thermal, mechanical and chemical resistance
- Approved by almost all well-known automotive manufacturers as well as by the Federal Office of Defence Technology and Procurement
- The surfaces must be clean, dry and free from grease
- Further information in the technical data sheet
Weight of content | 89.6 g |
Chemical basis | Polyurethane |
Colour | Red |
Density/conditions | 1.12 g/cm³ / at 25°C |
Min./max. temperature resistance | -50 to 270 °C |
Min. flashing point | -5 °C |
Silicone-free | Yes |